Generic filters

Revit®| Hagoita Bolt

Adds a Hagoita Bolt system between 2 Structural Members.


To apply the tool, Select the Structural Member(s) to be considered as the male joist(s).
Press the Enter key to apply the selection.
Select the Structural Member to be considered as the female joist(s).
Press the Enter Key to finish, otherwise, repeat the selection process.
Two Hagoita bolt instances could be inserted in each connexon, one on each side of the beam.

Instance Parameters


A= hsbcad Plate Length
B= hsbcad Plate Width
C= hsbcad Plate Thickness
D1= hsbcad Male Sink Hole Diameter
D2= hsbcad Female Sink Hole Diameter
D3= hsbcad Male Drill Diameter
D4= hsbcad Female Drill Diameter
E= hsbcad Female Sink Hole Depth  
F= hsbcad Female Drill Depth
G= hsbcad Male Sink Hole Depth   
H= hsbcad Male Drill Depth
I1= hsbcad Female Drill Positive Offset
I2= hsbcad Female Drill Negative Offset
J1= hsbcad Male Drill Positive offset
J2= hsbcad Male Drill Negative Offset
K1= hsbcad Male Drill (Check)
K2= hsbcad Male Drill (Uncheck)
L1= hsbcad Flip Side (Uncheck)
L2= hsbcad Flip Side (Check)
M1= hsbcad Center Beam Offset (Possitive)
M2= hsbcad Center Beam Offset (Negative)
N= hsbcad Drills Tolerance
Updated on 23/09/2021

Was this article helpful?

Related Articles

Need Support?
Can’t find the answer you’re looking for? Don’t worry we’re here to help!
Contact Support