Element TSL

This tsl placed saw and mill lines to selected zone of an Element. Line segments connected to an internal corner are done with a mill.

This tsl sets the main direction of the element to the direction of the rafters. The tsl makes it possible to change the UCS of a roof element.

This tsl makes it possible to enlarge the beams on sheet joint.Only for Roof Elements.

This tsl inserts drills as a reference position. The drills are placed along a vertical and/or horizontal line.

This tsl Replicates elements, child elements are depending on a master element to visualize entities. This is the main Tsl that is used to create replicated elements.

This tsl mills a profile in the beams of an element.

This tsl tries to restore the Element outline. This tsl resets the zone outline to the outline of zone 0.

This tsl numbers modules (opening). The modules are numbered per element.

This tsl swaps the UCS of an object or Entity, height/width/length of a sheet will be corrected to the correct values. Only for Roof Elements.

This tsl applies a naillines to a zone you select.

This tsl creates nail clusters to nail one zone on anther zone. The nail clusters are centered, with the specified offsets, in the intersecting areas between the 2 zones.

This tsl marks sheeting edges over beams.

This tsl inserts a line pattern on a specified zone.

This tsl places a ladder between 2 beams.

This tsl placed markerlines on the selected zone. The tsl adds lines at the start and the end of the studs/rafters/joists. The length of the markerlines can be specified in the properties.