Sheeting distributions for Roof/Floor

Distribution 1

This distribution can be used to divide sheeting in roof and floor elements. In this division, the edge of the sheet will always be on a Rafter or beam.

The sheeting width will be adjusted to meet the Rafters or beams.

The sheeting will only get smaller than what is entered in the dialog box, never bigger.

A: Enter the width of the sheet (add the gap value (B) to this entry)
B: Enter the gap.
C: Enter the height of the sheet.

Distribution 2

This distribution can be used to divide sheeting in roof and floor elements.

This division does not take the rafters or beams in account.

If the sheeting is bigger than the Center Center of the rafters or beams it will place it next to the rafters or beams.

The sheeting is divided from left to right and the rest will be placed on the right hand side.

Distribution 3

This distribution can be used to divide sheeting in roof and floor elements.

This division does not take the rafters or beams in account.

If the sheeting is bigger than the Center Center of the rafters or beams it will place it next to the rafters or beams.

The sheeting is divided from right to left and the rest will be placed on the left hand side.

Distribution 4

This distribution can be used to divide sheeting in roof and floor elements.

In this division, the sheeting is placed transverse to the rafters or beams.

The sheeting is divided from bottom to top and the rest will be placed on to top side.

Distribution 5

This distribution can be used to divide sheeting in roof and floor elements.

In this division, the sheeting is placed transverse to the rafters or beams.

The sheeting is divided from the top to the bottom and the rest will be placed on the bottom side.

Distribution 6

This distribution is intended for a full sheet, you only need to enter a thickness and material.

Distribution 7

Distribution 8

With this distribution you can add an extra lath above and under the rafters or beams.

The lath will run in the same direction as the rafters or beams.

The center of the lath will be placed on the center of the rafters or beams.

A: Enter the width of the lath

Distribution 9

With this distribution you can add extra laths above and under the rafters or beams.

The laths will run transverse to the rafters or beams.

The start point of the division is in the center of the element and the center of the rafters or beams.

Distribution 10

With this distribution you can add extra laths above and under the rafters or beams.

The laths will run transverse to the rafters or beams.

The start point of the division is in the center of the element and in the center of 2 rafters or beams.

If you want to return to the original document
How to create Roof-Floor panels - Sheeting