General TSL

This tsl draws the name of block that the master TSL set this one with.

This tsl sets the wall information to Square, Shaped or Special base on some rules.

This tsl adds a Column Foot with Glued rods.

This tsl adds a Column Foot with Fin Plates.

This tsl is used to mill around openings.

This tsl creates a sheeting under the elements.

This tsl calls the exporter for a specific group with all the entities or only the selected ones.

This tsl convert the beams with a beam code into sheets and assign it to a specific zone.

This tsl convert any beams that match section size to one of the profiles described in the properties.

This tsl creates a table in modelspace with the wall group, wall code, wall height, pitch, nailing information and lintel information of the selected elements.

This tsl creates a stud or circle when centres between studs have been exceeded.

This tsl rip the left and right stud when the king stud is overlapping them or rip the king stud when it is outside of the wall outline.

This tsl cuts the angle plate that intersect the bottom plate and if necessary apply a blocking piece.

This tsl moves the left and right studs back to the location of the sheeting zone define by the material.

This tsl creates battens around openings with an option to exclude doors, this battens will be assign to a zone of the element.