General TSL

This tsl Cuts in an angle the blocking that intersects the angled top plates leaving a clean connection.

This tsl calculatse the cavity closer base on the height of the openings or the width of the doors and export an Element with the information to the dBase.

This tsl converts a stud with code "BOXBLOCK" into 2 pieces of 200mm length on top and bottom of the panel.

This tsl Calls the Exporter for a specific group with all the entities or only the selected ones.

This tsl creates a small profile shopdraw with the dimensions of every beam that is not rectangular and quantify them.

This tsl create horizontal battens in openings, it will take in consideration if they are opening assemblies too if the TSL "hsb_SetModuleOnWindowDoorAssembly" is used prior to this one.

Settings for batten distribution construction plugin.

This tsl assigns a TSL none exclusively to the group of all the element selected.

This tsl assigns truss entity to element.

This tsl assigns sheets to a zone of an element.

This tsl assigns entities to a loose group.

This tsl assigns beams to a zone of an element.

This tsl assign beams with a specific code to a floor level group specify by a property.

This tsl gives you the possibility to set a point to use as 0 point for export to ifc.

This document will explain how to use the hsbStacking / truck loading tsl's. This is done by using an example project.