Panel-CLT-SIP

Masterpanel nesting is used in hsbcad to minimize the production waste of the CLT panels during manufacture. This document will show you how to create a nesting and apply company settings to optimize the process.

This tsl will add Electricity to a Panel Element.

This tsl has been replaced by the hsbCLT-Electra. This tsl will add Electricity to a Panel Element.

This tsl creates Rothoblaas XYLOFON noise absorbers at panel edges or edges, resulting from throughout beamcuts.

This tsl creates dimensions in the wall elevation layout for the element, openings and panels in the 4 sides of the wall.

This tsl corrects the width and height convention of timbers generation.

This tsl set's the material of the SIPs inside a wall.

This tsl shows the type of surfaces which are used for the selected panel. This tsl will add the visible and none visible side.

This tsl modifies an edge detail of sip panels.

This tsl will make a U opening in the panel Element.

This tsl rotates the x-axis of the sips 90 degrees, if the width is greater than the length.

This tsl makes a dove tail between a beam and a CLT Panel.

This tsl will put a header above an opening.

This tsl modifies existing windows or doors like openings in an existing panel such that any corner will receive a fillet with the given radius.