Panel-CLT-SIP

This tsl assigns electrical symbols to an installation object. This tsl is used by hsb_P-InstallationPoint.

This TSL converts solids into hsbPanels under respect of typical CLT requirements.

This tsl converts a given 3DSolid into an hsbPanel. When inserted the user flip, rotate and reassign the panel direction.

This tsl will split your panel and add a lapjoint.

This tsl creates a drill distribution along X-Direction of a genbeam, optional one can connect additional genbeams with it. This tsl calculates the required lifting system depending from the given parameters, the panel weight and it's point of gravity.

This tsl has been replaced by the hsbGrainDirection. This tsl will put the grain direction on the panel.

This tsl supports any extruded solid shape if the extrusion profile consists exclusively of straight segments.

This tsl creates a bill of material table for master panels.

This tsl will put the grain direction on the panel. This tsl has replaced the old hsbPanelGrainDirection.

This tsl generates pseudo log elements based on child stickframe wallsrenamed (replaces hsbPanelCLTWall), element tsl's triggered before command ended style detection enhanced, beamcuts on T-Connections enhanced.

This tsl creates a joint board between 2 panels and determine the placement of the board.

This tsl creates X-Fix connectors between panels.

This tsl creates a T-shaped connector for CLT panels.

This tsl will stretch a panel through a line with the given bevel.

This tsl adds properties to panels.