I have very small hsbWall details

Issue:

My details in the stickframe seem very small.
When using the stickframe empty for the first time you might get a funny looking detail in the H1-H2-H3-H4-T1-T2-E, when you use the command ‘’Update details in DWG’’.

Cause:

The cause of this is because the hsbSettings are set to INCH.

Solution:

BLOCK_CHECK_START

Step 1. Once you have set it back to ‘’mm’’ don’t forget to ‘’Update details in DWG’’ again.

Step 2. When you do this you will get a few messages.

Step 3. Select OK in both dialog boxes.

BLOCK_CHECK_END

This is the result you should have, a correct looking Detail.

‍