Panel-CLT-SIP

This tsl defines a rabbet / tenon joint between T-connected panels.

This tsl creates a pocket (mortise) with an optional explicit radius rounding on one face of one or multiple coplanar panels. During insert it filters redundant panels of the selection set.

This tsl creates a single or double rebate around an opening. It can be attached to any opening or the minmal size can be filtered during insert.

This tsl splits panels at an opening and extents the header panel by the given value.

This tsl will create drills for the lifting device.

This tsl calculates the required lifting system depending from the given parameters, the panel weight and it's point of gravityOne can release the lifting device collection into individual devices.

This tsl will create drills for the lifting device.

This tsl defines a joint board connection on one common edge between at least two panels. On insert it may create a split if only one panel was selected.

This tsl defines a lap joint on one edge between at least two panels.

This tsl will add Electricity to a Panel Wall. This tsl replaces the hsbPanelElectra tsl.

This tsl defines a split location on a wall element.

This tsl defines a dove tail connection or a butterfly spline as G-Connection (Mitre) between at least two panels.

This tsl defines a dove tail connection or a butterfly spline on an edge between at least two panels. On insert it may create a split if only one panel was selected.